We promise you the earth, and then we deliverEarthing Heaven Grounding Products. We promise the Earth, and then we deliver.

 

EARTHING PRODUCTS TESTING EQUIPMENT

SOCKET (POWER POINT) TESTER

EARTHING Heaven Grounding Products - Socket Tester to confirm the power point is installed correctly.

SOCKET (POWER POINT) TESTER
Price: $19.00
WHAT IS AN AUSTRALIAN EARTHING PRODUCTS SOCKET (POWER POINT) TESTER?
An Australian Earthing Products Socket (Power Point) Tester (hereafter called a Socket Tester) allows you to easily confirm that your electrical power points are correctly wired and that the Earth pin does allow your Earthing Products to effectively carry free electrons to your body.

SPECIFICATIONS:
The Socket Tester is a quality product made to strict standards.  It is designed to operate at 240 volts and 50 Hz as per Australian power grid parameters.  In one procedure you can very easily test all three pins of your power points to confirm the electrical configuration satisfies stringent Australian standards.   – (See photograph above).

GETTING STARTED:
Simply plug the Socket Tester into the electrical power point you wish to test, and turn on the switch.  If all three neon amber bulbs glow, the power point is installed correctly, and you can safely and effectively operate your Earthing Products with confidence and peace of mind.  There are four other possible configerations which are clearly outlined on the front face of the Socket Tester – (See photograph above).  Should any of these four configurations be determined by your Socket Tester, do NOT use that power point and contact a registered electrician to correct the faulty wiring.

It must be stressed that even if your power outlet socket is not wired correctly, there is no danger of electrocution when using our Earthing Products, because our products have built in safety protection.  However, if your outlet socket is not wired correctly then you would not receive the benefits of grounding.

Please note that it is the responsibility of the home owner or work place owner to check that their electrical power outlets are in good working order.

PRODUCT TESTER

EARTHING HEAVEN Grounding Products - Product Tester to confirm the Earthing Product is working correctly.

PRODUCT TESTER
Price: $39.00
WHAT IS AN AUSTRALIAN EARTHING PRODUCTS PRODUCT TESTER?
An Australian Earthing Products Product Tester (hereafter called a Product Tester) allows you to easily confirm that your Earthing Products are working effectively, and carrying free electrons to your body.

NOTE that the “Splitter” at the top Right Hand Side of the photograph above is NOT included!

SPECIFICATIONS:
The Product Tester is a quality product made to strict standards.  It is designed to confirm that your Earthing Products are operating correctly.  It can be used to test all of the Earthing Products.

GETTING STARTED:
Simply plug the male prong of the Product Tester into the female bung of an Adapter Plug which is inserted into an electrical power point.  Note that the electrical power point does NOT have to be turned on.  Make sure that the Earthing Product you wish to test is also plugged into an Adapter Plug which is inserted into an electrical power point.  Alternatively, if you are using a Grounding Rod the same setup applies.  A green light on the Product Tester confirms that the Earthing Product is working correctly.

TROUBLESHOOTING:
In the unlikely case that no green light comes on, the Earthing Product may be defective or may have lost its conductivity. However, sometimes people have difficulty testing their cotton products, including the Recovery Bag, Fitted Sheets, Half Sheet and Throw / Blanket, so please read the following:
If the Product Tester green light doesn’t come on, place one hand anywhere on the Product while holding the Product Tester in the other hand and with one finger on the silver detector button on the back of the Product Tester.  A green light confirms that the body is grounded when touching the Product. Make sure that both the Product Tester and the Product are plugged into the wall outlet Adapter Plug or the Ground Rod as described above. One reason for the green light not coming on can be that you aren’t pressing hard enough on the Product Tester. The surface fabric of the Product sometimes prevents the detector button from contacting the conductive silver fibres sufficiently. The surface of the Product seems smooth, but if you were to look at it under a microscope you would see “hills and valleys”. Unlike the hard metal detector button on the Product Tester, the pliant surface of the skin on your fingers will mould around the cotton fibres and make good contact with the conductive silver fibres.  Alternatively, you can moisten your fingertips while performing the test, to create a better contact with the conductive silver fibres.

GET INSTANT ACCESS to FREE WELLNESS NEWSLETTERS

I supply WELLNESS Newsletters to my patients and all other parties who are interested in optimizing their health and wellness potential. ANTRAC WELLNESS Newsletters are jam-packed full of current powerful health-related information to help you attain optimal wellness and vitality and start living life to the full. Did I mention that the Newsletters are FREE? To confirm my promise of supplying vital information on all health issues, CLICK on “Wellness Newsletters” Navigation Bar above to sample the rich contents of the Newsletters.

If YOU haven’t already signed up and you would like to receive future ANTRAC WELLNESS Newsletters every 3 weeks hot off the press to your inbox, just click the Opt-In link below and supply your Email Address, First Name and Last Name. Subscription is absolutely FREE. How easy is that? I do NOT send out SPAM or supply your details to anyone else.